Energy UNITS FOR LIFT TABLE 1
Common Description
This energy unit is designed exclusively for your smaller lift table,Consisting of high pressure gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This power unit continues to be widely applied within the field of logistic products including minifork lift, scissors lift and ariel working platforms. The lower-ing motion is controlled by the solenoid valve with all the velocity controlled from the adjustable needle valve.
Power UNITS FOR LIFT TABLE 2
Basic Description
This electrical power unit is designed solely for the medium lift table, Consisting of hugely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering movement is actived from the solenoid valve as well as the pace controlled from the adjustable needle valve. Once the lift rises to a substantial positoin, however the electrical power provide is minimize, the lowering movement is controlled through the guide override function.
Energy UNITS FOR LIFT TABLE 3
Standard Description
This power unit is intended solely for the huge lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived through the solenoid valve along with the velocity controlled by a pressure compensated flow control valve.
Energy UNITS FOR LIFT TABLE 4
Basic Description
This energy unit is intended solely for the massive lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived from the solenoid valve as well as velocity managed through the adjustable needle valve. When the lift rises to a large positoin, but the electrical power supply is cut, the decreasing movement is controlled through the manual override perform.
Particular Notes
1. This electrical power unit is of S3 duty cycle, which might only get the job done intermittently and repeatedly, i.e. one minute on and 9 minutes off.
two. Clean the many hydraulic components concerned ahead of installation of the power unit.
3. Viscosity in the oil shoud be 15~46 cst,which need to also be clean and absolutely free of impurities.N46 hydraulic oil is suggested.
4. Oil modifying is needed soon after the initial one hundred operation hrs,afterwards once each and every 3000 hours.
5. The electrical power unit proven is built to be mounted vertically.